|
http://tinyurl.com/36k8p
You are here: Pure Energy Systems > Open
Sourcing > Magnetic
Motors > MXLO
> Replications
> Ed Anderson
Ed Anderson's Replication of the MXLO Magnetic Motor
Sent: Friday, March 26, 2004 8:59 AM
Subject: MXLO engine???
Hi Sterling:
Yes you can use my feed back on the MXLO project.
Enclosed is a picture of my assembled unit.
I even invested in a precision ground end mill to embed the magnets in precise order.
Results? NADA
You would think that with all my manufacturing experience and my other inventions that are world
wide I should be a qualified developer if the plans were correct. You can check me out at www.lilorbits.com
Regards,
Ed Anderson
From: "mnglobal" <info@mnglobal.com>
To: <FE_updates@yahoogroups.com>
Sent: Thursday, March 25, 2004 4:38 PM
Subject: Re: [FE_updates] MXLO Magnet Motor Assembly Instructions
Hi Sterling:
Yes I purchased their "plans" and assembled them exactly as instructed.
But it does not work. I revisited their web site and I see they have included a Copper strip
in addition to the aluminum strip. It seems these plans change daily!
I used neodymium magnets to the size they stipulated and spent much time in machining the whole
contraption. There is no free spinning
regardless how I place the fields. They keep saying "patience is needed to fine tune the
apparatus"
Have you gotten any feed back from others who have purchased these plans?
Your friend,
Ed Anderson
About Ed
See also
Page posted by SDA
March 26, 2004
Last updated March 27, 2004 04:36:17 AM MST
| 
